Pairfect Socks?



An update on my coronasock exploits...

I wrote a blog about coronasocks a while back - you can read it here, but do grab a cuppa first, cos it's a long one!

There I detailed progress so far; six pairs of coronasocks completed, and my first lot of sock wool hand dyed. I also finished a pair of socks that had been begun by a friend's mum-in-law, but I didn't count them as I was only completing someone else's project.

The good weather meant I had a break from socks after that. I spent time in the garden instead, did a bit of editing, and reconnected with Discworld. However, the last couple of days I've been feeling a bit rough. I don't think it's THE virus, but I have been fatigued and achey and out-of-sorts, so I'm keeping to home and picked up the knitting again.

I knitted my hand dyed wool.

My lovely rainbow-dyed hank

And I was very disappointed.

The  lovely rainbow wool didn't knit a rainbow at all...it knitted speckly. And there was LOADS of cream - the original base colour of the undyed wool - which made some of the colours knit as stripes. And the lovely vibrant colours...weren't. Well, not in the first sock.

First sock at the bottom, second still on pins at the top

The first sock came out all muted tones - the yellow and orange were really pale. The second sock - well, the colours were much brighter. I did toy with the idea of knitting a third sock and seeing which two out of the three matched best, but they didn't look too bad once they were finished; 


I've obviously got a lot to learn about placing colours on the hank at the dyeing stage if I want to get thicker stripes. Or limit myself to two or three only...

But that's Pair number 7 completed. Feeling a bit rough still, I started on Pair 8: Pairfect Socks. 

The theory behind Pairfect Socks is that the ball has enough wool for two socks, which will match perfectly, because a section of yellow wool is the marker for the beginning/end of the colour pattern repeat which is the end/top of each sock. 

It sounded intriguing and I rather liked the pattern as shown on the label.

The reality is...different.

For a start, if I knitted the socks up as on the label, they'd be knee-highs. So I had to keep breaking into the wool to take bits out. I could've just knitted through I suppose - but I didn't. Here's the first sock:

Spot the differences...

And here's the wool left over from it...


Not the most economical of ways to knit matching socks - I'll end up with exactly the same little balls once the second sock's completed, too. 

To be honest, I've never had much problem matching my socks when using non-pairfect socks, so I don't think I'll bother using this kind of novelty approach in future.

Ah well, you live and learn! And I'm off to knit coronasock number 16.
Previous
Previous

Squidge's Writing Prompt #3

Next
Next

Once a writer, always a writer?